Mopar R/H Thread Dimple Lug Nuts (Set of 10)
From the early 1930s on, Chrysler put left-hand threaded studs on the driver side of its cars, a quirk that still trips up owners and tire shops today. The practice ended during the 1970-1971 changeover: a Technical Service Bulletin stated that all 1971 Chryslers, Imperials and Plymouths would use right-hand threads on both sides, and by 1972 right-hand studs were standard at all four corners. That history is why lug nut shopping for a 1970-1974 Mopar starts with checking the threads, and this set covers the right-hand side of the equation.
Specifications
- Thread: 1/2"-20, right-hand
- Hex: 3/4"
- Overall length: 1.25"
- Seat: dimple (cone) style for factory-style wheels
- Quantity: 10 nuts (PG Classic 244-RHSET)
How Many Sets You Need
With five studs per wheel, one set of ten covers two wheels. On a car that still carries left-hand studs on the driver side, this set handles the passenger side, and a matching left-hand set takes care of the other two corners. On a car with right-hand studs all around, which became standard across the line by 1972, two sets do the whole car. Decades of brake and axle work often leave mixed studs, so check every corner: original left-hand studs were usually stamped with an "L" on the end, and their nuts were often marked with notches or hash marks on top.
Fit and Use
The dimple style refers to the cone-shaped seat that centers the wheel on each stud, which is what factory-style wheels are designed to take. A nut with the wrong seat will not clamp the wheel properly and can work loose, so match the nut to the wheel before you mount it. Tighten the nuts in a star pattern to the factory torque specification, and recheck them after the first few miles on freshly mounted wheels. These nuts suit restorers replacing a mismatched or rusty set as well as owners who converted to right-hand studs during a brake upgrade.
Frequently Asked Questions
Are these for the passenger side or both sides?
It depends on your studs. On a car with left-hand driver-side studs, these go on the passenger side; on a car with right-hand studs at every corner, they work on both sides and two sets cover the car.
How do I tell if my car has left-hand studs?
Look at the end of each stud for a stamped "L," which Chrysler typically used to mark left-hand threads. Original left-hand nuts were often marked with notches or hash marks on top as well.
Will these fit aftermarket mag wheels?
Only if the wheel calls for a cone-seat nut with this thread and length. Many aftermarket wheels use a different seat or a shank-style nut, so check the wheel maker's specification first.
