Mopar B-Body Air Grabber Box
Plymouth's Air Grabber and Dodge's Ramcharger systems only work as well as the box under the hood that ties the scoop to the air cleaner, and on most surviving B-bodies that box is the piece that has rusted, cracked at the welds or been thrown away during an engine swap. Without it, a restored scoop is just decoration. PG Classic's 102-BOX reproduction accepts the Air Grabber door assembly and seals the system so outside air actually reaches the carburetor.
Construction
The box is stamped steel with factory-style welds and flanges, so it looks right when the hood is open at a show and stands up to engine-bay heat. The mounting holes are pre-drilled at the original bracket locations, which takes the guesswork out of lining it up with your existing hardware. It ships in raw steel, ready to be painted or plated to match whatever finish your restoration calls for.
Applications
This box is listed for the 1969-1972 B-body range: Dodge Coronet and Charger, and Plymouth Belvedere, GTX, Road Runner and Satellite. Fresh-air hoods varied by year and model across those cars, so check that your hood, scoop and air cleaner are the Air Grabber style before ordering, particularly on a car that has had its hood replaced at some point.
Finishing and Install
Because it arrives bare, plan your finish before the box goes on the car. Most restorers prime and topcoat it to match their engine-bay detail, while others send it out with the rest of their plated hardware. Fit the door assembly and seals on the bench first, then mount the completed box at the original bracket points and check the seal against the hood before the final tightening.
Frequently Asked Questions
Does the box come painted?
No, it is supplied in raw steel so you can paint or plate it to suit your restoration. Prime it promptly after unboxing to keep surface rust from forming.
Is the Air Grabber door included?
The listing is for the box itself, which is made to accept the Air Grabber door assembly. Reuse your original door or order a reproduction door separately.
Will it bolt to my original brackets?
Yes, the mounting holes are pre-drilled at the original bracket locations. Inspect your brackets for rust or bends before installing, since a tweaked bracket will throw off the seal against the hood.
