1969-1970 Charger Sequential LED Tail Light Conversion, ORACLE RETRO 8209-023
Few muscle cars are identified by their tail lights the way the B-body Charger is. Whether your car is a 1969 or a 1970, a base car, a 500 or an R/T, the rear view is part of what makes it a Charger. ORACLE Lighting built the RETRO 8209-023 conversion to leave that view alone and change only what happens behind the lens. The bulbs and sockets come out, vehicle-specific LED boards go in, and the factory lenses and housings go right back on.
Performance You Can See
The kit carries more than 3,000 LEDs. That density gives a smooth, uniform glow across the lens, with none of the isolated bright spots common to low-count LED bulbs. Individually controlled LED sections run a fluid sequential turn signal across the lamp and an animated startup sequence when the running lights come on. Running and brake functions use high-output SMD LEDs for a strong, modern brake light on a car that originally had very little.
Respects the Original Car
For many classic Mopar owners, the deciding factor is the wiring. This kit does not require cutting, tapping or modifying the factory tail light harness. It connects with plug and play connectors and mounts with the factory hardware at the original gasket locations, with no adhesive strips. That keeps the upgrade fully reversible on a restored car, and clean and reliable on a restomod or show car.
Features at a Glance
- ORACLE RETRO Classic Vehicle LED Tail Light Series
- More than 3,000 LEDs
- Full dynamic sequential turn signals with animated startup
- High-output LED running and brake lights
- Aluminum PCB assemblies designed for the Charger
- Factory mounting hardware and gasket locations
- Plug and play wiring, no harness modification
- Original lenses and housings retained
- 2-year warranty
Installer Tips
Disconnect the battery before starting any electrical work. Most classic cars still run a thermal flasher, which may hyper-flash once the LED load is installed; swapping to an electronic LED flasher relay is the fix. The kit includes plug and play wiring connections and full installation instructions.
FAQ
Will it work with reproduction tail light lenses?
The kit is designed around the factory lens and housing, so good quality reproductions built to factory dimensions should work. Your original lenses can also be reused.
Is the conversion reversible?
Yes. It uses factory mounting points and plug and play connectors, so the original bulb sockets can be reinstalled.
What else might I need?
An electronic LED flasher relay is the only additional part that may be required.
Who makes it?
ORACLE Lighting, a USA designed and engineered lighting manufacturer, and it carries a 2-year warranty.
