1967-1969 Plymouth Barracuda Front or Rear Bumper with Holes
Chrysler used a single bumper design at both ends of the second-generation Barracuda, which is why one part number covers the front and the rear here. That makes this a practical buy for a restoration: the same reproduction bumper replaces a pitted front bar, a dented rear one, or both, and the two ends will match in finish and contour.
The bumper is stamped from heavy-gauge steel and finished in quality chrome, with the profile and bolt pattern of the original. The "with holes" designation means it is drilled for bumper guards. If your car wore the guards, this is the correct version; for a car without guards, a separate no-holes version keeps the bumper face clean. Check your car's original configuration, or the holes in your old bumper, before you order.
Installation Notes
The bumper mounts to your existing brackets or reproduction brackets, which are sold separately, using new bumper bolts. Inspect the brackets and their mounting points on the frame rails before fitting, since rust there is common on these cars and will throw off the gaps. Test-fit before final tightening, then adjust the brackets so the bumper sits evenly against the body at both ends. At roughly 23 pounds, it is manageable for one person to fit, though a helper makes alignment easier. Protect the fresh chrome with masking tape or a moving blanket while you work so a slipped wrench does not leave a mark. Coat the bolt threads with anti-seize so the bumper can come off easily in the future.
Frequently Asked Questions
Is this the front or the rear bumper?
Both. The 1967-1969 Barracuda used the same bumper front and rear, so this one part fits either end.
What does "with holes" mean?
It is drilled for bumper guards. Choose this version if your car has, or will have, the guards installed.
Are brackets and bolts included?
No. The bumper mounts to your original or reproduction brackets, which are sold separately.
